Eibach sportline spring lowering suspension for Opel astra mk5(h) vxr 2.0t. This product sheet is originally written in English. Please find below a machine translation in French. If you have any questions please contact us.
We can supply all eibach products, including lowering springs, coilovers, anti-roll bar/stabilising bar kits, spacers, etc. If not named separately, vehicles with original raised suspension (e. Offroad-package, crossover) are excluded from the use of eibach products. The specifications specified in the component certificate are for the classification of the article/vehicle. Please check your car's component type certificate number and compare with the component certificate.
Letter k on your certificate of registration or to find on the nameplate of your car! -Please check before installation using the component certificate if the components delivered (see marking) are approved for your vehicle (see field of use). In case of non-compliance the elements should not be mounted thanks to contact your dealer.
Assembly - we recommend that you have our spring system installed only by a qualified workshop, which has qualified staff and the necessary special tools. If the installation differs from the workshop manual, the eibach-eibach instructions are available online. Mounting position - you can read the mounting position of the springs from the print - install them exactly as you read the print.
Wheel adjustment - once the spring/suspension has been installed, it is necessary to check the adjustment of the wheels. Shock absorbers - if the standard shock absorbers are no longer fully operational and their efficiency has deteriorated considerably, we strongly recommend replacing them with new standard shock absorbers or sports shock absorbers, if you use lower springs. This may already be necessary from 40,000 kilometers oe-damper-milage. The installation of sport-shock shock absorbers is recommended with the sportline springs. As an example bilstein b8 - here, all wheel/pneu combinations are possible, which are validated by the wheel type test institute. The instructions of the wheel component certificate must be followed, except for: an original suspension is required. Depending on the engine, gear/transmission, equipment and vehicle tolerances, the descent may be different from the values indicated. The descent rating shall be reduced by the descent rating carried out by the manufacturer. The applicability of eibach products concerns standard cars. In all cases of reconstruction (even with parts of original accessories), such as the installation of an accessory braking system (e. Ceramic brakes), a sports suspension, a gpl system (liquefied petroleum gas), for example, the use of eibach products may be excluded. The measurements indicated refer to new standard cars. Measuring points: vertical distance between the middle of the wheel hub and the lower edge of the mud wing. Generally, the measurements given are nominal values, which may vary depending on each car. A7If your vehicle is equipped with a serial electronic shock absorber control, it will no longer be available when using the b12 or pro-street-s suspension kit. You will see a breakdown code. This can be reprogrammed by an official garage/concessionaire. If available for your vehicle, we recommend using pro-tronic to avoid breakdown code. Except vehicles with 4 wheel drive.Increase in axle load when using a trailer (see component certificate). The specifications specified in the component certificate are for the classification of the article/vehicle. A7if your vehicle is equipped with a damper control. This item is in the category "auto, motorcycle - parts, accessories\tuning, styling\suspension\short spring kits".
The seller is "wg_motorparts" and is located in this country: gb. This item can be shipped to the following countries: america, europe, asia.